Phytoremediation of a Petroleum‐Hydrocarbon Contaminated Shallow Aquifer in Elizabeth City,North Carolina,USA

A former bulk fuel terminal in North Carolina is a groundwater phytoremediation demonstration site where 3,250 hybrid poplars, willows, and pine trees were planted from 2006 to 2008 over approximately 579,000 L of residual gasoline, diesel, and jet fuel. Since 2011, the groundwater altitude is lower in the area with trees than outside the planted area. Soil‐gas analyses showed a 95 percent mass loss for total petroleum hydrocarbons (TPH) and a 99 percent mass loss for benzene, toluene, ethylbenzene, and xylenes (BTEX). BTEX and methyl tert‐butyl ether concentrations have decreased in groundwater. Interpolations of free‐phase, fuel product gauging data show reduced thicknesses across the site and pooling of fuel product where poplar biomass is greatest. Isolated clusters of tree mortalities have persisted in areas with high TPH and BTEX mass. Toxicity assays showed impaired water use for willows and poplars exposed to the site's fuel product, but Populus survival was higher than the willows or pines on‐site, even in a noncontaminated control area. All four Populus clones survived well at the site. © 2014 Wiley Periodicals, Inc.*     

磷石膏水热法合成硫酸钙晶须

以磷石膏为原料，二水合硫酸钙、硫酸镁、甘油为添加剂，采用水热法合成硫酸钙晶须，考察了料浆含量、反应温度、反应时间、体系pH等因素对晶须的直径和长径比的影响；并采用SEM技术观察硫酸钙晶须的形貌。实验结果表明，当磷石膏含量2.5%（w）、反应温度130 ℃、反应时间4 h、体系pH 4时，制备得到的硫酸钙晶须长径比为56.24，平均直径为0.17 μm。SEM表征结果显示，硫酸钙晶须形貌规整、分散均匀、直径较小，达百纳米级。     

过硫酸钾去除水中的TCE

以地水中的氯代烃污染物三氯乙烯(TCE)为目标污染物,以过硫酸钾溶液为氧化剂,探讨了不同条件下过硫酸钾对TCE的去除效果。实验结果表明,在40℃,过硫酸钾初始浓度为2.43 g/L条件下,反应2 h后,TCE的去除率就可达到96.8%;过硫酸钾对TCE的去除符合一级反应动力学方程,速率常数(K)为1.3364 h-1,半衰期(t1/2)为0.51 h;过硫酸钾对TCE的去除速率在pH为中性附近时最大,其后无论pH升高或降低去除速率均减小;受温度和pH影响较明显,并且反应温度越高,受pH的影响越明显;随离子强度的增加而减小;反应活化能为119.6 kJ/mol;过硫酸钾溶于水生成过硫酸根离子(S2O28-),S2O28-会进一步生成硫酸根自由基(SO4-.),在碱性条件下,SO4-.与OH-反应会进一步生成羟基自由基(.OH)。过硫酸钾对于TCE的去除主要源自SO4-.和.OH的强氧化性。     

Heavy metal contamination in a vulnerable mangrove swamp in South China

Concentrations of six heavy metals (Cu, Ni, Zn, Cd, Cr, and Pb) in sediments and fine roots, thick roots, branches, and leaves of six mangrove plant species collected from the Futian mangrove forest, South China were measured. The results show that both the sediments and plants in Futian mangrove ecosystem are moderately contaminated by heavy metals, with the main contaminants being Zn and Cu. All investigated metals showed very similar distribution patterns in the sediments, implying that they had the same anthropogenic source(s). High accumulations of the heavy metals were observed in the root tissues, especially the fine roots, and much lower concentrations in the other organs. This indicates that the roots strongly immobilize the heavy metals and (hence) that mangrove plants possess mechanisms that limit the upward transport of heavy metals and exclude them from sensitive tissues. The growth performance of propagules and 6-month-old seedlings of Bruguiera gymnorhiza in the presence of contaminating Cu and Cd was also examined. The results show that this plant is not sufficiently sensitive to heavy metals after its propagule stage for its regeneration and growth to be significantly affected by heavy metal contamination in the Futian mangrove ecosystem. However, older mangrove seedlings appeared to be more metal-tolerant than the younger seedlings due to their more efficient exclusion mechanism. Thus, the effects of metal contamination on young seedlings should be assessed when evaluating the risks posed by heavy metals in an ecosystem.     

常温条件下2种厌氧折流板反应器处理淀粉废水的启动实验

为了研究厌氧折流板反应器在常温下的启动情况,在22.5～30.2℃条件下,对不加填料的5隔室厌氧折流板反应器和加填料的4隔室复合式厌氧折流板反应器同步进行了启动实验。实验用水为高浓度淀粉废水,两反应器采用相同的启动策略,即梯度增加进水COD浓度与降低水力停留时间相结合的方式。两反应器有效容积均为47.8 L,启动初始负荷为0.6 kg COD/(m3.d),逐渐增加到10 kg COD/(m3.d)。实验表明,经过6个阶段87 d的运行,反应器启动完成,并成功培养出颗粒污泥,两反应器对COD的去除率都能达到85%以上。在启动过程中两反应器对COD的去除效率相近。     

好氧颗粒污泥自生动态膜生物反应器处理碱减量印染废水

自生动态膜生物反应器(SFDMBR)接种颗粒污泥启动,研究溶解氧浓度和水力停留时间对该反应器处理碱减量印染废水的影响。自生动态膜生物反应器形成稳定的动态膜后,出水浊度小于10 NTU,系统对浊度的去除率在90%以上,溶解氧和水力停留时间对反应器出水浊度基本无影响。系统对废水色度的去除率随着溶解氧浓度的提高和水力停留时间的延长而增加,但是系统对色度的去除效率一般不超过40%。溶解氧浓度由0.3 mg/L逐渐增大至2.4 mg/L,COD的去除率由40%提升至80%,而当溶解氧浓度大于1.0 mg/L后,UV254的去除率达到95%。水力停留时间在8~48 h时,COD去除效率由65%逐渐上升至85%左右;水力停留时间在8~32 h,UV254去除效率为68%~93%,超过32 h后水力停留时间对UV254去除效率的影响已不明显。     

Climate Change and Population Growth in Timor Leste: Implications for Food Security

The climate in Timor Leste (East Timor) is predicted to become about 1.5 °C warmer and about 10 % wetter on average by 2050. By the same year, the population is expected to triple from 1 to 2.5–3 million. This article maps the predicted changes in temperature and rainfall and reviews the implications of climate change and population growth on agricultural systems. Improved cultivars of maize, rice, cassava, sweet potato and peanuts with high yield performance have been introduced, but these will need to be augmented in the future with better adapted cultivars and new crops, such as food and fodder legumes and new management practices. The requirements for fertilizers to boost yields and terracing and/or contour hedgerows to prevent soil erosion of steeply sloping terrain are discussed. Contour hedges can also be used for fodder for improved animal production to provide protein to reduce malnutrition.     

粒状羟基氧化铁对废水中硝酸盐的吸附

本实验研究了粒状羟基氧化铁(GFH)对人工配制含氮废水中NO3--N吸附的影响因素、吸附等温线和吸附动力学。结果表明,GFH的吸附平衡时间为80 min,增加NO3--N溶液的初始浓度,去除率下降;pH值为5时GFH对NO3--N的吸附能力最强,pH值升高和降低,吸附能力均下降;GFH对NO3--N的吸附能力随着温度的升高略有降低;在25℃下,以Langmuir方程和Freundlich方程分别对GFH吸附NO3--N的等温线进行拟合,拟合效果以Langmuir方程较好,相关性达到0.9930。GFH吸附NO3--N的过程符合拟二级动力学方程,初始时刻的吸附速率h在35℃时最大,为1.653 mg/(g.mg),吸附速率常数随温度的升高而增大;吸附反应的活化能Ea为54.72 kJ/mol。本研究结果表明,GFH在饮用水脱氮和含氮浓度较低的污水再生回用领域有实际应用的潜力。     

A techno-economic comparison of fluidized bed gasification of two mixed plastic wastes

A comparison between the most promising design configurations for the industrial application of gasification based, plastics-to-energy cogenerators in the 2-6 MWe range is presented. A pilot scale bubbling fluidized bed air gasifier, having a feeding capacity of 100 kg/h, provided experimental data: the syngas complete composition, the characterization of the bed material, the entrained fines collected at the cyclone and the purge material from the scrubber. Mass and energy balances and material and substance flow analyses have been therefore drawn to assess and compare design solutions utilizing two mixed plastic wastes (MPW) obtained from separate collection of plastic packaging, after different levels of pre-treatments. The related techno-economic performances have been finally estimated on the basis of the manufacturer’s specifications. The study concludes that the MPW obtained after a very simple pre-treatment and fed to a gasifier coupled with a steam turbine is the solution that currently offers the higher reliability and provides the higher internal rate of return for the investigated range of electrical energy production.     

Determination of specific gravity of municipal solid waste

This investigation was conducted to evaluate experimental determination of specific gravity (G_s) of municipal solid waste (MSW). Water pycnometry, typically used for testing soils was adapted for testing MSW using a large flask with 2000 mL capacity and specimens with 100–350 g masses. Tests were conducted on manufactured waste samples prepared using US waste constituent components; fresh wastes obtained prior and subsequent to compaction at an MSW landfill; and wastes obtained from various depths at the same landfill. Factors that influence specific gravity were investigated including waste particle size, compaction, and combined decomposition and stress history. The measured average specific gravities were 1.377 and 1.530 for as-prepared/uncompacted and compacted manufactured wastes, respectively; 1.072 and 1.258 for uncompacted and compacted fresh wastes, respectively; and 2.201 for old wastes. The average organic content and degree of decomposition were 77.2% and 0%, respectively for fresh wastes and 22.8% and 88.3%, respectively for old wastes. The G_s increased with decreasing particle size, compaction, and increasing waste age. For fresh wastes, reductions in particle size and compaction caused occluded intraparticle pores to be exposed and waste particles to be deformed resulting in increases in specific gravity. For old wastes, the high G_s resulted from loss of biodegradable components that have low G_s as well as potential access to previously occluded pores and deformation of particles due to both degradation processes and applied mechanical stresses. The G_s was correlated to the degree of decomposition with a linear relationship. Unlike soils, the G_s for MSW was not unique, but varied in a landfill environment due both to physical/mechanical processes and biochemical processes. Specific gravity testing is recommended to be conducted not only using representative waste composition, but also using representative compaction, stress, and degradation states.